EndRun Sonoma D12, Руководство пользователя

Страница: 99 / 172

S o n o m a U s e r M a n u a l 82
C H A P T E R N I N E
83 S o n o m a U s e r M a n u a l
C O N T R O L A N D S T A T U S C O M M A N D S
setsigfltmask
This command allows you to enable or mask the Signal Loss Fault. Parameter for this command is
either MASKED or ENABLED. Setting this command to MASKED will prevent a signal loss fault
from creating an alarm condition. Some installations may need to mask this fault when operating the
NTP server as a Stratum 2 server. The factory default setting is ENABLED.
Command:
setsigfltmask MASKED
Sonoma reply:
Signal Loss Fault Mask set to MASKED
sigfltmask
This command displays the current setting for the Signal Loss Fault Mask.
Command:
sigfltmask
Sonoma reply:
Signal Loss Fault is ENABLED
subsysreset
This command performs a CDMA Subsystem reset which is similar to cycling the power on the
CDMA Subsystem. It also resets the CDMA Receiver. After about 10 seconds, the boot messages
from the CDMA Subsystem will be displayed.
Command:
subsysreset
Sonoma reply:
Bootloader 6010-0070-000 v 1.00 - Dec 27 2012 14:48:55
FW 6010-0071-000 v 1.00 - Mar 02 2013 17:48:28
FPGA 6020-0012-000 v 01
Wait 20 seconds while resetting CDMA Receiver...
Done.
syskernel
This command returns the currently booted linux kernel, either 0 or 1, where 0 is the factory-installed
kernel and 1 is the upgraded kernel.
Command:
syskernel
Sonoma reply:
BOOTED KERNEL IMAGE = 1 (Upgrade)
sysosctype
This command displays the system oscillator type. It is either TCXO, OCXO or Rubidium. The
standard oscillator type is the TCXO.
Command:
sysosctype
Sonoma reply:
Installed Oscillator is TCXO.