EndRun Sonoma D12, Руководство пользователя

Страница: 50 / 172

S o n o m a U s e r M a n u a l 34
C H A P T E R F O U R
35 S o n o m a U s e r M a n u a l
P T P / I E E E - 1 5 8 8
Two Gigabit Ports
The PTP daemon status and configuration is supported from two PTP companion utilities
ptpstatx
and
ptpconfigx
, where x is network port 0 (
eth0)
or 1 (
eth1)
. The following table shows the
Sonoma utilities that pertain to PTP:
Daemon Status Configuration
PTP
ptpd0
ptpd1 ptpstat0
ptpstat1 ptpconfig0
ptpconfig1
PTP can be enabled on one or both network ports (
eth0
and
eth1
). If PTP is enabled on only one
port, then
eth0
is the network port identifier and you would use
ptpstat0
and
ptpconfig0
for
PTP status and configuration. If PTP is enabled on both ports, then both
eth0
and
eth1
will be used.
PTP Configuration
and Status
The default PTP configuration settings in the Sonoma are shown below. If you need to modify these
settings then you will need to reconfigure the PTP Subsystem. You may perform the configuration
from either a
telnet
or
ssh
session, or the local RS-232 console. Default PTP settings are:
Port 0 (eth0) Port 1 (eth1)
Sync Interval 1 second 1 second
Announce Inverval 2 seconds 2 seconds
Priority 1 128 128
Priority 2 128 128
Delay Mechanism E2E E2E
Domain 0 1
PTP Time Mode PTP PTP
PTP TTL 1 1
PTP Configuration and Status Using the Keypad/Display
If your unit has the optional PTP capability then there will be an item in the list of Main Menu selec-
tions called: “PTP”. Press the RIGHT/LEFT arrow key until this is highlighted and press ENTER
to select it. Then press the RIGHT/LEFT arrow keys to highlight “Status” or “Setup” and press
ENTER.
The “Status” selection will let you see the current status of the PTP Subsystem.
For the “Setup” selection, press EDIT to reconfigure PTP. The sequence of edit displays will guide
you through the setup process. Press the HELP key at any time to view the context-sensitive help
information. When you are finished the unit will reset.