Endress EZG 24/2, Руководство по эксплуатации

Страница: 14 / 18

14
.
6. Insert the cardan joint (not in the scope of delivery) between the generator and
the tractor
(for a switched off tractor) , whereby one must
ensure perfect coupling so that the machine both in idle and at a high speed is
completely free of vibrations.
7. Make sure that the generator's support structure sits
firmly on the ground: Rotation of a raised generator
is not permissible
. The vibrations can cause inadequate
functionality of the three-phase generator and risk of causing
an accident
8.
Safety inspection before commissioning (see p.
10).
9.
Start the tractor and
integrate the drive that provides the generator movement. Increase the rotational
speed step by step
until the frequency measuring device on the electrical control panel
reaches 52 Hz without a load.
10. Insert the plug in the corresponding socket.
Make sure the appliances connected to the generator
are suitable.
---------------------------------------------------------------------------------------------------------
Particularly ensure that there are no persons in the vicinity of the axial shaft
(within a distance of 1m) during the whole period of operation.
11.
If the tractor does not deliver the required performance under load
and the frequency is significantly reduced (below 48Hz),
engage the accelerator in order to bring the frequency up to
the correct value (50 Hz). One must take account of the fact that
a tractor is connected to the three-phase generator
apart from the fact that it loses speed when under load
. When disconnecting the load from the three-phase generator overvoltages
and excessively high rotational speeds can occur,
and these voltage and frequency changes can
be damaging for other loads which are connected at the same time
.
Stopping the machine: Remove the individual loads, whereby
one starts with the lighter ones or set the main switch to
OFF/0, switch off the tractor and pull out the power plug.