Endress ESE 608 DHG ES DI DUPLEX, Руководство по эксплуатации

Страница: 34 / 55

34
Version: January 2013
4.6
Monitoring the operating status using
the multifunction display
All LEDs light up for about 2 seconds to allow checking as
soon as the START-STOP switchis set to the position
“RUN”. The normal operational lighting is then shown after-
wards for about 30 seconds. If the engine is not started with-
in this period, the E-MCS 4.0 goes into energy saving mode
and the display goes dark. To bring the E-MCS 4.0 back into
a ready-to-operate condition again, the START-STOP switch
must first be turned into the position “OFF The display inten-
sity depends on the ambient light.
Figure 4-5: Multi-functional display
Displayed
(see Figure 4-54(1))
when the generator has started
or is activated for 30 seconds when the START / STOP
switch is turned to the “Operate” position.
If the display is red
(see Figure 4-54-(16))
whilst the generator is
running, the temperature is too high and the generator must
be switched off.
(Only active if the special “Warning signal II”, “Firecan” option is fitted!)
Operating hours:
Ambient temperature: