Endress+Hauser TopClean S CPC 30, Руководство по эксплуатации

Страница: 5 / 146

TopClean S CPC 30 1 Safety instructions
Hauser 5
1.2 Designated use
The system is supplied complete with power supply cables and bottle hoses. The Ex
version of the TopClean S CPC 30 allows operation even in explosive atmospheres. In
the Ex version, the CPG 30 is powered via the communication/power supply cable from
the Mycom S CPM 153. In the non-Ex version, the CPG 30 and the CPM 153 are
connected directly to the power supply.
The manufacturer is not liable for damage caused by improper use or use other than
that for which it is intended.
1.3 Installation, commissioning and operation
Note the following points:
•
If the system is used improperly or other than for its designated use, it may pose a
hazard, e.g. due to improper connection.
•
Installation, electrical connection, commissioning, operation and maintenance of the
measuring system must therefore be carried out exclusively by trained specialists
authorised by the system operator.
•
Technical personnel must have read and understood these Operating Instructions
and must adhere to them.
•
Always follow the regulations in your country pertaining to the opening and repairing
of electrical instruments.
1.4 Operational safety
#
Warning!
If the device is used for any application other than those described in these Operating
Instructions, it may lead to unsafe and improper functioning of the measuring system
and is therefore not permitted.
The instruments have been designed and tested according to the state of the art and
left the factory in perfect functioning order. The instruments meet all the prevailing
regulations and EC directives - see "Technical data".
However, always pay attention to the following points:
•
Measuring systems used in Ex areas have separate documents which form a
component part
of these Operating Instructions. Always follow the installation
regulations and the connection data. You can find the following symbols on the front
page of the additional Ex documentation (according to approval and test centre
(
0
Europe,
2
USA,
1
Canada).
•
The measuring device complies with the general safety requirements in accordance
with EN 61010, the EMC requirements of EN 61326, and NAMUR Recommendation
NE 21, 1998.
•
The manufacturer reserves the right to change the technical data in line with technical
progress at any time. You can obtain information on the current version of this
Operating Instructions and possible additions from your E+H sales centre.