Basic safety instructions
Overfill Prevention System SOP300
6
Hauser
Any other use is considered to be non-designated use. Designated use entails compliance with
the operating and maintenance requirements specified by the manufacturer. The Overfill
Prevention System must be installed in a safe environment (not in hazardous areas or Ex
zones). We recommend that you install the Overfill Prevention System in a dry, air-
conditioned room.
Dangers
It is the responsibility of the owner/operator to assess any dangers for the systems.
These dangers must be assessed by the owner/operator and the measures resulting from
the assessment must be implemented. While the Overfill Prevention System can form
part of such a measure, responsibility for the entire safety function always rests with the
owner/operator, particularly the taking of suitable measures if the Overfill Prevention
System signals an alarm. We also specifically state that relevant measures must also be
assessed from a process engineering perspective.
Incorrect use
Non-designated use can compromise safety. The manufacturer is not liable for damage
caused by improper or non-designated use.
2.3
Occupational safety
Personnel must meet the following conditions when working on and with the system:
‣
Wear the required personal protective equipment according to regional/national
regulations.
‣
When welding, do not ground the welding unit via the system.
‣
If hands are wet, wear gloves on account of the higher risk of electric shock.
2.4
Operational safety
Operate the system only if it is in proper technical condition, free from errors and faults.
The operator is responsible for the interference-free operation of the system.
2.5
Product safety
This device is designed in accordance with industry practice to meet state-of-the-art safety
requirements, has been tested, and left the factory in a condition in which it is safe to operate.
It meets general safety standards and legal requirements. It also complies with the EC
directives listed in the product-specific EC Declaration of Conformity. Hauser
confirms this by affixing the CE mark to the device.
2.6
IT security
We only provide a warranty if the system is installed and used as described in the Operating
Instructions. The system is equipped with security mechanisms to protect it against any
inadvertent changes to the device settings.
Содержание SOP300
Страница 29: ......
Страница 30: ......
Страница 31: ......
Страница 32: ...www addresses endress com...