Endress+Hauser Proservo NMS83, Руководство по эксплуатации, Страница: 96 / 318

Commissioning Proservo NMS83
96 Hauser
9.5.2 Configuration of a connected NMT532/NMT539
If a NMT532 or NMT539 temperature transmitter is connected via HART, it can be
configured as follows:
1. Navigate to: Expert → Input/output → HART devices → HART Device(s) → NMT device
config
2. Go to the Configure device? parameter and select Yes .
3. Go to the Bottom point parameter and enter the position of the bottom temperature
element (see picture below).
a
A0030165
 49 Position of the bottom temperature element
a Distance from bottom temperature element to zero reference (tank bottom or datum plate). The standard
factory default setting is 500 mm (19.69 in), and it can be adjusted according to the actual installation.
To check the temperatures measured by the individual elements, go to the following
submenu: Expert → Input/output → HART devices → HD @ X NMT+WB
3)
→ Element
values.
For additional information on settings, refer to the Operating Manual of the
Prothermo NMT532 or NMT539.
3) In this expression, "X" is the HART address of the NMT. Its default value is "2".