Endress+Hauser promag 30, Руководство по эксплуатации

Страница: 47 / 72

6.3 Replacing the transmitter electronics
Caution!
•
When replacing the electronic boards, ensure that their markings are identical.
•
The local power supply voltage and frequency must be the same as the technical
specifications of the power supply boards.
ba00
8y
3
6
Procedure:
Warning!
Danger from electric shock! Switch off the power supply before removing
the cover to the electronics area of the transmitter housing. Switch off the power supply
(isolating the measuring system)
1. Loosen the Allen screws of the safety grip (3-mm Allen key).
2. Unscrew the cover of the electronics area of the transmitter housing.
3. Remove the local display (if present):
a) Loosen the mounting screws of the display module.
b) Unplug the ribbon cable of the display module form the amplifier board.
4. Remove the 2-pole plug of the power supply cable by pressing the catch of the power supply
board at the same time (Fig. 43: V4).
5. Remove the cable board of the screened signal cable from the amplifier board (Fig. 44: V5).
6. Loosen the two Phillips screws of the board support plate. Carefully remove the support plate
approx. 4–5 cm out of the transmitter housing.
7. Remove the coil current cable plug from the power supply board (Fig. 43: V1).
8. Remove the ribbon cable plug (connection cable to the connection terminal area) from the am-
plifier board (Fig. 44: V8, V9).
9. The entire transmitter electronics, together with the board support plate can now be completely
removed from the housing.
10. If necessary, remove the DAT module from the pin strip (Fig. 44: V 10) on the amplifier board:
– Required when replacing the transmitter electronics
→
plug the old DAT in the
new amplifier board.
– Required when replacing a defective DAT
→
plug the new DAT on the old amplifier board.
11. Replace the old transmitter electronics with new transmitter electronics.
12. Reassemble in reverse sequence.
Fig. 42
Promag 30 6. Fault Location and Remedies
Hauser 47