Endress+Hauser Proline Cubemass C 300, Руководство по эксплуатации

Страница: 158 / 216

Diagnostics and troubleshooting Proline Cubemass C 300
158 Hauser
Available status signals
Configuration as per HART 7 Specification (Condensed Status), in accordance with
NAMUR NE107.
Symbol Meaning
A0013956
Failure
A device error is present. The measured value is no longer valid.
A0013959
Function check
The device is in service mode (e.g. during a simulation).
A0013958
Out of specification
The device is being operated:
• Outside its technical specification limits (e.g. outside the process temperature range)
• Outside of the configuration carried out by the user (e.g. maximum flow in parameter
20 mA value )
A0013957
Maintenance required
Maintenance is required. The measured value is still valid.
A0023076
Has no effect on the condensed status.
12.7 Overview of diagnostic information
In the case of some items of diagnostic information, the status signal and the
diagnostic behavior can be changed. Change the diagnostic information →  157
Diagnostic
number
Short text Remedy instructions Status
signal
[from the
factory]
Diagnostic
behavior
[from the
factory]
Diagnostic of sensor
002 Sensor unknown 1. Check if the correct sensor is
mounted
2. Check if the 2-D matrix code on the
sensor is undamaged
F Alarm
022 Temperature sensor
defective 1. If available: Check connection cable
between sensor and transmitter
2. Check or replace sensor electronic
module (ISEM)
3. Replace sensor
F Alarm
046 Sensor limit exceeded 1. Check process conditions
2. Check sensor S Warning
1)
062 Sensor connection faulty 1. If available: Check connection cable
between sensor and transmitter
2. Check or replace sensor electronic
module (ISEM)
3. Replace sensor
F Alarm
063 Exciter current faulty 1. If available: Check connection cable
between sensor and transmitter
2. Check or replace sensor electronic
module (ISEM)
3. Replace sensor
F Alarm
082 Data storage
inconsistent Check module connections F Alarm
083 Memory content
inconsistent 1. Restart device
2. Restore S-DAT data
3. Replace S-DAT F Alarm