Cerabar S 4 to 20mA HART
Description of parameters
Hauser
19
ALTERNATE DATA (423)
Options
Switch on "Alternating display" mode.
In this display mode, the onsite display alternates between the following measured values
depending on the measuring mode selected.
– Pressure: primary value (PV), pressure, temperature and current
Options:
• Off
• On
Factory setting:
Off
LANGUAGE
Selection
Select the menu language for the onsite display.
!
Note!
• In the case of local operation, the LANGUAGE parameter is arranged directly under
the GROUP SELECTION (menu path: GROUP SELECTION
LANGUAGE, see also
Page 10).
• Select the menu language for the operating program via the "Options" menu
"Settings"
"Language" tab
"Tool Language" field.
Options
:
• Deutsch
• English
• Français
• Italiano
• Español
• Nederlands
• Chinese (CHS)
• Japanese (JPN)
Factory setting
:
English
DISPLAY CONTRAST (339)
Entry
Adjust contrast of onsite display.
You specify the contrast of the display with a number. Changes are only accepted as single
steps, i.e. to change the value from "8" to "4", you need to save four times. You can also
adjust the contrast of the display by means of the keys on the electronic insert or at the
device.
See also Operating Instructions BA00412P, the section on operating keys function.
Input range:
4...13, 4: contrast weaker (brighter), 13: contrast stronger (darker).
Factory setting:
8
DIGITS SET (840)
Display
This parameter is used to verify correct display of characters and digits on the user
interface. If the characters and digits are correctly displayed, this parameter shows the
string "0123456789.-".
Table 6: (GROUP SELECTION
) OPERATING MENU
DISPLAY
Parameter name
Description
