Endress+Hauser Analytik Jena multi EA 4000, Руководство по эксплуатации

Страница: 13 / 151

multi EA 4000 Safety instructions
13
2.5 Safety instructions - operation
2.5.1 General
The operator of the analyzer must make sure before each commissioning that the con-
dition of the analyzers including the safety equipment is sound. This applies in particu-
lar after each modification or extension of the analyzer or its repair.
The following has to be observed:

The analyzer must only be operated if all protective equipment (e.g. covers, drip
pans for chemicals and doors) are present, properly installed and operational.

The sound condition of the protection and safety equipment must be checked regu-
larly. Any defects must be corrected as soon as they occur.

Protective and safety equipment must never be removed, modified or switched off
during operation.

Free access to the power switch on the back of the enclosure has to be ensured dur-
ing operation.

The ventilation equipment on the multi 4000 and the extension modules must be
in good working condition. Covered ventilation grilles or slits etc. may cause the de-
vice to break down or may cause damage to it.

The analyzer must not be switched on without a heated combustion tube.

The furnace operates with temperatures of up to 1500 °C. The hot components
(furnace, gas sluice, dust trap, boat) must not be touched during or directly after
the operation of the analyzer.
In manual operation, the hot boats must be deposited on the surface of the manual
feed or on some other heat-resistant surface.

During automatic cooling, do not interrupt the power supply. In case of prolonged
power failure during operation disconnect the mains plug and open the ride side
panel of the basic device to prevent damage from overheating. When removing the
side panel there is a risk of injury from sharp-edged components. To not touch the
heating elements or the hot furnace!

Keep all combustible materials away from the analyzer.

At the autosampler there is a risk of crushing! The autosampler arm, the gripper
and the boat carousel move during activation, initialization, adjustment and meas-
urement operation. Keep an adequate distance to avoid having your hands crushed.
2.5.2 Safety instructions - Protection against explosion and fire
The analyzer must not be operated in an explosive environment. Smoking or handling
open flames in the operating room of the analyzer is prohibited!
The operating personnel must be familiar with the location of the fire-fighting equip-
ment in the operating room of the analyzer.