Endress+Hauser 485, Руководство по установке

Страница: 23 / 24

Kit CM44x Wiring
Hauser
23
6.3 Bus termination (module 485 only)
There are two ways to terminate the bus:
1. Internal terminating resistor (via DIP switch on the module board)
‣
Using a suitable tool, such as a tweezers, set all 4 DIP switches to the "ON" position.
 The internal terminating resistor is used.
a0016306
Fig. 24: Structure of the internal terminating resistor
2. External terminating resistor
Here, leave the DIP switches on the module board in the "OFF" position (factory setting).
‣
Connect the resistor to terminals 81 and 82 on the front of module 485 for 5-V power
supply.
 The external terminating resistor is used.
Fig. 23: DIP switches for internal terminating resistor