Endon Lighting
LS9 0SE
20150706
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
N210 109
Diagram A
Diagram B
1.
Diagram A.
Determine the
position of your light fitting.
Ensure there is sufficient
power cable to connect to
the fitting – we recommend
at least 250mm. Ensure
that the mounting surface
is solid. If you are using
anchor bolts (not supplied)
prepare the mounting
surface as appropriate (and
ensure that there are no
other cables or pipes
beneath the surface).
2. Place the base over the
cable and use it as a
template to mark the
mounting hole positions.
Drill and plug the holes
ready to mount the fitting
later.
3.
Diagram B.
Pull the
terminal block assembly
out of the base of the
fitting. Remove the cable
clamp and take the lid off
the terminal block housing
to expose the internal
terminal block.
4.
C
onnect the house wiring to
the internal terminal block.
NOTE:
This is a Class I
fitting and
must be
earthed.
Connect the
incoming mains as per the
WIRING DETAILS
diagram
5.
Re-fit the terminal block into
its housing and secure –
ensuring that all seals are
correctly located.
6.
Secure the cable clamp
over the incoming cable
and then push the terminal
block assembly as far into
the base / stem as
possible.
7. Secure the post (screws /
bolts etc not supplied) to
the mounting surface
making sure that all
cables are contained
inside the fitting.
8. Turn on the power and
test.
Cable clamp
WIRING DETAILS
