Pagoda PIR Outdoor Wall Light (13924)
Safety Warnings
INSTRUCTION MANUAL
This is a Class 1 product and must be earthed.
• Please read these instructions carefully before commencing any work, and retain for reference
.
• Install in accordance with IEE Wiring regulations and current Building Regulations.
• To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other
persons cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult
a qualified electrician.
• This light fitting should be connected to a circuit with a 30mA RCD fitted.
• When changing a bulb, always switch off at the mains and allow the old bulb to cool before handling.
Dispose of used bulbs carefully and responsibly. Do not exceed the wattage stated or use a different shape
bulb as indicated on the fitting. This product is not suitable for dimming.
• Waste electrical products should not be disposed of with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for recycling advice.
This product is rated at IP44. It is not suitable for location in or near a marine or sea
environment. The shade must be replaced immediately should it become cracked or
damaged. This fitting must not be used without the shade in place.
Endon Lighting, LS9 0SE
Assembly/ User Instructions
Before you start
Check the packaging and make sure that you have all the required parts. Follow each assembly step in order
to prevent incorrect assembly. Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block(s).
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Care Information
Do not use solvents or abrasive cleaners, as these could damage the finish.
Do not clean the units with a
pressure washer.
In normal circumstances, stainless steel is very resistant to corrosion, but may require maintenance to
preserve the high quality appearance: Wash the product with warm soapy water, removing all surface
deposits. Rinse with clear water, and with a soft cloth, wipe dry.
In some cases, surface corrosion may arise after installation. This is normally caused by tiny iron particles left
behind during production. Wash and dry as above, then wipe over with a soft cloth soaked with protective oil.
If the product is subject to extreme environmental conditions, such as marine locations or industrial pollution,
these maintenance procedures should be carried out around four times a year. For severe corrosion, non-
abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the corrosion then
treated as above.
Glass parts - Remove and wash in warm water or just use a damp cloth.
35895-Pagoda_PIR-WB 20160720
Layout
• Plan the desired layout of this fitting carefully, ensuring the cables will reach the distance between the
junction box and the light fitting.
• Avoid locating any cables in positions that would cause a hazard. Position cables and outdoor rated junction
boxes (not supplied) away from areas where they may be at risk from being cut, trapped or damaged.
