1
The Light pack contains:
Light fitting with decorative glass balls.
Terminal connection block(s).
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
INSTRUCTION MANUAL
These products are only suitable for connection to a 240V~50Hz supply in accordance with current
IEE wiring Regulations and should be installed in accordance to local UK Building Regulations and
are for Domestic ceiling use only and not suitable for a Bathroom location.
The light fitting should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
This product contains glass parts – be careful during handling and maintenance to avoid breakage.
This fitting uses none-replaceable LED`s. As with all LED`s we recommend that you do not stare
directly into the light beam.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
This fitting is heavy / awkward and you may require assistance in connecting it to the supply and
securing it to the mounting surface. When fixing to the mounting surface ensure that the fixings
used are appropriate for the mounting surface on which they are being used.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Before you start
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws / nuts, including electrical connections etc are fully tightened before use.
This type of Light Fitting cannot be connected to a Dimmer.
Muni – CH and Muni – CO (Chrome and Copper LED Pendants).
Safety Warnings
