Endon Lighting
LS9 0SE
20150928
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
W28 25
Diagram A
Diagram B
1.
Diagram A.
To take off the front cover undo and
remove the 3 screws as shown – retain for re-use.
2.
Diagram B
. Determine the position of your light fitting
taking into account the exit position of the cable.
Ensure that the mounting surface is solid, preferably a
brick or block wall and ensure that there are no other
cables or pipes beneath the surface. Use the back
plate as a template and mark the 2 fixings holes. Bring
the cable through the grommet ensuring that there is
sufficient cable coming out of the wall to connect to the
terminal block. Use appropriate fixings to secure the
back plate to the wall, making sure the back plate is
correctly aligned. Fix the back plate to the wall.
3.
Diagram C
. Connect the house wiring to the internal
terminal block. The cable entry grommet must be
securely in place to ensure that the water ingress
protection is maintained.
NOTE:
This is a Class I
fitting and
must be earthed. See wiring details.
4.
Fit the appropriate bulb (supplied) into the lamp holder
NOTE:
Never fit bulbs of a higher wattage or of a
type other than those specified on the label (as
these may cause overheating and damage the
fitting).
5.
Re-fit the front cover and secure with the screws
removed in 1 above. Make sure that all the internal
cables and connections are inside the back plate and
away from the bulb. Take care not to trap or strain the
internal cables.
6. Turn on the power and test.
Diagram C
WIRING DETAILS
Incoming supply cable
