Endon
LS9 0SE
20150324
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Assembly / user instructions
P570 07
Diagram A
Diagram B
Diagram C
1.
Diagram A
. Determine the position of your light fitting
taking into account the exit position of the cable.
Ensure that the mounting surface is solid, preferably a
brick or block wall and ensure that there are no other
cables or pipes beneath the surface. Use appropriate
fixings. Wall plugs and screws as supplied are shown
here.
2.
Separate the plastic back plate from the fitting by
removing the two domed nuts on the front of the fitting.
Leave the threaded (1) bolts in the back plate. Use the
back plate as a template to mark the screw holes.
Make sure the back plate is correctly aligned.
3.
Diagram B
.
Use a sharp object such as a screwdriver
to pierce the rubber grommet in the back plate. Feed
the incoming cable (2) through the rubber grommet and
attach the back plate to the wall. Do not over tighten as
this could damage the back plate.
4.
Diagram C
. Connect the house wiring to the internal
terminal block. The terminal block can be removed
from its mount for ease of connection.
NOTE:
This is a
Class II fitting and
must not be earthed.
If you have
any earth cables make sure that they are connected to
each other – to maintain earth continuity throughout
your property – and wrap them in insulation tape and
keep them away from the terminal connections of the
fitting.
5.
Diagram D.
Place the fitting over the back plate,
ensuring that the bolts in the back plate are aligned
with the holes in the front of the fitting. Replace the
domed nuts (3) to secure the fitting. Do not over
tighten. Fit the LED bulb (supplied) into the lamp
holder.
NOTE:
Never fit bulbs of a higher wattage
or of a type other than those specified on the label
(as these may cause overheating and damage the
fitting).
6.
Diagram E
. Fit the bulb cover
7.
Turn on the power and test.
Diagram D
Diagram E
(1)
(1)
(2)
(3)
Internal
cable
s
