Endon Lighting, LS9 0SE
76826_76834-Lincoln-WB 20180626
Adjusting the PIR Sensor
• The unit must be installed in a vertical position
• For the best results, fix the product to a solid surface, 1.8-2.5m above the ground.
• Avoid aiming the PIR sensor at pools, heating vents, air conditioners or objects which may change
temperature rapidly.
• Try to avoid pointing the unit at trees or shrubs, or where the motion of pets may be detected.
• The PIR Sensor is more sensitive to motion across the detection area than motion towards it, therefore
consider this when planning the position of the product.
• The PIR sensor is fully adjustable, allowing the detection distance to be altered to suit the location. The
detection angle is set at an optimum 120
o
. The duration the lamp stays on can also be altered from 5 seconds
- 8 minutes. Use a small screwdriver to gently adjust the ‘TIME’ and ‘SENS’ screws. When adjusting the
sensitivity (detection distance) in daylight it will be necessary to simulate night time. Alternatively, sensitivity
adjustments can be made at night. This is due to a daylight photocell sensor which de-activates the product
during daylight hours
