Addison Outdoor Wall Light
Safety Warnings
INSTRUCTION MANUAL
•
This is a Class 1 product and must be earthed.
• Please read these instructions carefully before commencing any work and keep them for future reference. It is
recommended that this fitting is installed by a qualified electrician.
• Install in accordance with the current IEE Wiring regulations and current Building Regulations.
• To prevent electrocution switch off at mains supply before installing or maintaining this fitting. Ensure other persons
cannot restore the electrical supply without your knowledge. If you are in any doubt, please consult a qualified
electrician.
• This light fitting should be connected to the 5/6 amp fused lighting circuit in your home.
• If replacing an existing fitting, make a note of the connections.
• Always use the correct type and wattage bulb. Never exceed the wattage stated.
• When changing a bulb, always switch off at the mains and allow the old bulb to cool down before handling.
• Dispose of used bulbs carefully.
• This product is IP44 rated and is suitable for outdoor use.
76597
-Addison-WL 20180611
Endon Lighting, LS9 0SE
Assembly/ User Instructions
Please read these instructions carefully before fitting and retain for reference.
Check the packaging and make sure that you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Ensure that the product is fully assembled as illustrated before use.
The Light pack contains:
Light fitting.
Terminal connection block.
Fixing pack.
The following tools may be required:
Selection of cross and flat head screwdrivers.
Electric drill and assorted drill bits.
Wire strippers.
Electrical insulation tape.
Personal protection equipment
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
Before you start
Care Information
Allow 10 minutes to cool before replacing, adjusting or cleaning.
In normal circumstances, stainless steel is very resistant to corrosion. It does however require maintenance to preserve
the high quality appearance. Wash the product with warm soapy water, removing all surface deposits. Rinse with clear
water and with a soft cloth, wipe dry. In some cases, surface corrosion may arise after installation. This is normally caused
by tiny iron particles left behind after the polishing process when finishing. Wash and dry as detailed above. Then with a
soft cloth soaked with a protective oil, wipe all over.
However if the product is subject to extreme environmental conditions such as marine locations, industrial pollution and
acid rain these maintenance procedures should be carried out around four times a year. For severe corrosion, non-
abrasive cream cleaners or proprietary stainless steel cleaners should be used to remove the corrosion. Wash and dry as
detailed above. Then with a soft cloth soaked with a protective oil, wipe all over.
Please note - This instruction covers multiple fitting styles. While all the steps to assemble your fitting will be the
same, your individual product may vary from the diagram shown below.
1. Remove the finials (A) and rubber washers (B) from the front of the product and lift the light fitting body away from the
wall back. Keep the finials and washers in a safe place for refitting later.
Refer to Assembly Diagram 2.
2. Using the wall back as a template, mark the position of the mounting holes. Drill holes and fit supplied wall plugs
(suitable for masonry only - for other surfaces use appropriate fixings). Make sure the wall back is
correctly oriented with the drain hole at the base. Take care not to damage any wiring or pipes
when drilling the holes.
Refer to Assembly Diagram 3.
