Thank you for purchasing this light fitting. Please read the instructions carefully before use to ensure safe and satisfactory
operation of this product. Please retain these instructions for future reference.
Warning
This product is Class 3
Please read these instructions carefully before
commencing any work.
This unit must be fitted by a competent and qualified
electrician.
This system contains non-replaceable parts and cannot be
serviced. If damage occurs the part should be scrapped.
This product is not suitable for dimming.
Waste electrical products should not be disposed of with
household waste. Please recycle where facilities exist.
Check with your local authority or retailer for recycling
advice.
Battery Care Warnings
DO NOT:-
Attempt to connect more than 1 battery box.
Mix battery types, or combine old and new batteries.
Short battery box supply terminals.
Attempt to recharge Non-Rechargeable Batteries.
Attempt to recharge rechargeable batteries without
removing from battery box.
Leave exhausted batteries in battery box.
Specification
Lamp: 1.5W LED Capsule Cool White - 3lm
IP rating: 44
Battery: 3 x 1.5V AA
Installation
• This mirror fixes to the wall by locating the keyhole
shaped slots over the mounting screws in the wall. It is
important to get the screw positions correct to ensure
easy and secure fitting.
• Measure the distance between the hole centres on the
fixing lugs. Mark the positions of the screw holes on
the wall. Check for concealed pipes and wiring before
drilling. Use suitable drill bits for masonry and ceramic
tiles.
• Supplied wall plugs are for solid walls only. For all other
wall types ensure correct fixings are used. Fit appropriate
wall fixings and fit supplied screws. Screw heads must
protrude approx 3-5mm from the wall to enable lugs to fit
over adequately.
• To fit the shelf to the mirror, slot into fixing brackets
so shelf is centralised with mirror. Fasten grub screws
underneath to ensure shelf is retained securely. Do not
overtighten grub screws.
Layout
• This product is battery powered and is therefore exempt
from IEE wiring regulations concerning bathrooms.
• This product has special protection against the ingress
of moisture and is IP44 rated.
• This product is suitable for all areas of a bathroom.
The chosen location should allow for the product to be
securely mounted. (e.g. to a stud wall framework)
Fitting/Replacing batteries
•
This product requires 3x 1.5V AA batteries.
•
The performance of the product will depend on the
quality and type of batteries used.
•
Always use good quality batteries.
• Unclip battery box from mirror.
• Unscrew battery box cover. Insert 3x 1.5V AA batteries,
observing correct polarity.
• Replace battery box cover, ensuring bezel seal is properly
seated.
