2
Assembly/ User Instructions
These assembly diagrams are intended as a guide – if in doubt consult a qualified electrician.
I080 25
Diagram A
1. Decide on the position of the light fitting /
or remove existing light fitting. Take a
note of the position of the electrical
connections. Ensure there is a solid
mounting surface, preferably a wooden
joist or joist bridge to support the weight
of the light fitting.
2. See
Diagram A
. Remove the fixing
bracket by undoing the 2 side screws
(1), retain for re-use.
3. Use the fixing bracket (2) as a template
to mark the screw holes, mark the screw
holes and secure to the ceiling with the
screws (3) supplied.
4.
Diagram
B
. Support your tting and
connect the house wiring to the terminal
block (4) – see wiring details
. NOTE:
This is a Class I fitting and
must be
earthed
5. Secure the fitting back onto the fixing
bracket with the 2 side screws (1),
removed in 2 above. Make sure that all
the internal cables and connections are
inside the ceiling cup taking care not to
trap or strain the internal cables.
6. Fit the shades (5) and secure with the
shade ring (6) using the shade ring tool
(7) in the orientation shown.
7. Fit the bulbs being careful not to touch
the bulbs with your bare hands – use a
cloth or gloves to insert the bulbs.
NOTE; Never fit bulbs of a higher
wattage or of a
type other than those
provided / specified on the label (as
these may cause overheating and
damage the fitting).
8. Turn on the power and test.
Endon Lighting
LS9 0SE
20191127
WIRING DETAILS
Diagram B
