1
The Light pack contains:
Light fitting and mounting bracket
Terminal connection block
Shade ring tool
The following
tools may
be required:
Selection of flat and crosshead screwdrivers
Electric drill and assorted drill bits.
Wire strippers
INSTRUCTION MANUAL
These products are only suitable for connection to a 240V~50Hz supply in accordance with current
IEE wiring Regulations and should be installed in accordance with local Building Regulations and
are for Domestic indoor ceiling use only and not suitable for a Bathroom location.
The light fittings should be connected to a lighting circuit protected by a 5 amp fuse (or a 6 amp
miniature circuit breaker).
If in doubt we recommend you contact a qualified electrician. Before installing your light fitting
always:
Switch off the mains supply and remove the appropriate fuse or switch off the appropriate circuit
breaker before commencing installation.
Ensure that no one else has access that would enable the supply to be inadvertently reconnected.
Never fit bulbs of a higher wattage or of a type other than those specified on the label as this may
cause overheating and damage the fitting.
These product contains glass parts – be careful during handling and maintenance to avoid
breakage.
The bulbs become hot during use so please switch off and allow 10 minutes to cool before replacing
bulbs or cleaning the fitting.
This fitting is heavy and you may require assistance in connecting it to the supply and securing it to
the mounting surface. When fixing to the mounting surface ensure that the fixings used are
appropriate for the mounting surface on which they are being used.
Clean with a dry cloth only. Do not use liquid or abrasive cleaners on this product.
If any modification is made it will invalidate the warranty and may render the product unsafe.
Before you start
Please read these instructions carefully before fitting your new light and retain for reference.
Make sure that there are no pipes or cables beneath the mounting surface.
Check the packaging and make sure you have all the required parts.
Follow each assembly step in order to prevent incorrect assembly.
Make sure all screws/nuts including electrical connections are fully tightened before use.
This type of Light Fitting may be connected to a Dimmer if a Tungsten incandescent bulb is used. If
a CFL/LED type bulb is fitted then these cannot (generally) be controlled by a dimmer.
Boyer – 5AB/CH (Semi-Flush fittings)
Safety Warnings
