12
13
1. Apply masking tape as shown in the picture above on both sides
(4 marks).
2. Push the roller over the masking tape.
3. Using a pen, mark the position of the roller (left & right side) on the tape before
moving the beam.
4. Then lift the roller and push the Glide beam to the other end of the table and repeat
the procedure.
ADJUST THE
ROLLER POSITION
FOR THIS STEP YOU NEED:
■
Masking tape
■
Pen
■
Measuring tape
■
Allen key
NOTE
■
To obtain an exact
measurement, don’t start
measuring from the beginning
of the measuring tape. For
example, start measuring from
100mm.
5. Use the measuring tape to measure both diagonals from cross to cross. The measured distances must not deviate by more than 1 millimetre.
If measured length A is longer than measured length B, the roller must be adjusted in the direction of the arrow, and vice versa (see illustration).
If A is 4 mm longer then B, move the roller approximately 2 mm in direction of the arrow, and vice versa. To adjust follow the steps in picture 6-9.
A
B
7. Loosen the four screws holding the
air cylinder.
6. Remove overlaying panel on the
side you want to adjust. Measure the
distance from the piston to the edge of
the Aluminum profile and write it down,
so you don’t forget it.
8. Adjust the air cylinder. Move it right
or left depending on which way you
need to adjust the roller.
9. After adjusting the roller to the right
position, tighten the 4 screws holding
the air cylinder housing and then
reattach the overlaying panel.
