E9 OP REV.A1
13
Press and hold the transmitter
“
F
”
button first until 3 chirps are heard. Then press the
F
Button
three
more
times so that
TEMP
appears on the remote. Within 3 seconds press
button; the in-door temperature will be
shown on the LCD screen. This reading may be higher than actual ambient temperature due to the greenhouse
effect and is relative only to the inside vehicle temperature.
G. TO TURN OFF THE REMOTE START:
When the engine is running (by remote start), if you want to stop it,
1. Press
button once on the remote transmitter under the remote start mode.
2. Move the optional remote start enable toggle switch to OFF position. (If installed)
3. Press the brake pedal
The vehicle will shut down and turn off the parking light to indicate the engine has stopped.
H. SHUT-DOWN INPUT FOR REMOTE STARTER:
If any of the following conditions exist while the system is operating, the engine will not start or will shut
down immediately:
1. The hood is opened.
2. The brake pedal is pressed.
3. The parking (hand) brake is released (For Turbo Timer Mode)
4. Engine is over-revved. {“Tachometer checking type” only}
5. The pre-programmed run time
(5 /10 / 20 / 30 minutes)
has elapsed.
6. Press
button on the remote transmitter under remote start mode.
7. The system trigger.
8. The vehicle refused to start running after {3} unsuccessful attempts.
I. DISABLING THE REMOTE START SYSTEM: (If installed)
This feature allows your system’s remote start unit to be temporarily disabled to prevent the vehicle from being
remote started accidentally. This feature is useful if the vehicle is being serviced or stored in an enclosed area. To
disable the remote start, move the optional remote start enable toggle switch to the OFF position.
ADVANCED USER’S MODE:
LCD REMOTE TRANSCEIVER OPERATION:
Enter: Press and hold
F
Button until beep sound respond from LCD transceiver indicate into
table 1 – 5 as below.
Exit:
Press the
,
or
button to exit this mode.