Encore 32B100, Руководство оператора

Страница: 6 / 16

ENCORE
5
HEIGHT ADJUSTMENT
REAR DECK MOUNT IN HIGHEST POSITION
(5) spacers on top of caster arm = 1 7/8" to 3 1/8"
(4) spacers on top of caster arm = 2 1/8" to 3 3/8"
(3) spacers on top of caster arm = 2 1/2" to 3 3/4"
(2) spacers on top of caster arm = 2 5/8" to 3 7/8"
(1) spacer on top of caster arm = 2 7/8" to 4 1/8"
All spacers under caster arm = 3 1/4" to 1 1/2"
REAR DECK MOUNT IN LOWEST POSITION
(5) spacers on top of caster arm = 1 1/2" to 2 3/4"
(4) spacers on top of caster arm = 1 3/4" to 3"
(3) spacers on top of caster arm = 2" to 3 1/4"
(2) spacers on top of caster arm= 2 3/8" to 3 3/8"
(1) spacer on top of caster arm = 2 5/8" to 3 7/8"
All spacers under caster arm
= 2 7/8" to 4 1/8"
NOTE: Use 1/4" blade spacers to achieve cutting height between the above measurements.
Caster Arm Caster Arm
Caster Arm Caster Arm
Spacers
Spacers
Caster Assy Caster Assy
Blade Spacers Blade Spacers
Highest Highest
Rear Deck Rear Deck
Mount Position
Mount Position
Lowest Lowest
Fig. 4
LUBRICATION
(Units Prior to Serial Number 33333)
Grease Daily:
Idler Arm
Caster Wheels and Caster Pivots
Drive Wheels
Grease Every 100 Hours:
Bell Crank Pivot Bearing
Grease Every 250 Hours:
Cutter Housing Bearings
LUBRICATION / MAINTENANCE
The following recommendations should be used to ensure proper and safe operation of the
mower.
CAUTION:
When greasing Cutter Housing, grease
each one with
TWO PUMPS ONLY .
Excessive greasing can force seals out
causing premature bearing failure.