Enconnex Advanced Office-in-a-Box, Руководство пользователя

Страница: 20 / 40

DANGER
Read this section carefully as it deals with situations that may cause bodily injury or death.
4. Make sure the power is switched-off, locked and tagged out at the main supply
Circuit Breaker / Switch-fuse to the OIB Unit before the power meter test, and final
connections.
8. Commissioning
8.1. Inspection
●
Check that the power supply voltage is the same as the nominal voltage of
equipment on the nameplate.
●
Check that the system is correctly electrically connected.
●
Ensure all connections are secure, tight and terminated correctly.
●
Check that the rating value of the Circuit Breaker or Switch-Fuse is correct.
CAUTION
Read this section carefully as it deals with situations that may cause bodily injury or equipment damage.
Before commissioning please check the status of the unit according to table 8.1-1 below.
Item Checking Details and Request
Unit Appearance
There is no damage to the unit, the surface is clean and has been properly leveled
on a suitable surface
Electric Supply
Circuit
The power supply connection should be secure and terminated correctly then
measured and the pre-startup voltage values should be recorded..
Electrical Control
Panel
Electrical components in the 63A distribution control panel are in good condition.
Air Conditioning
Unit
No blockages at the supply air in, and air exhaust out.
Table 8.1-1: Checklist
8.2. Unit Start Up & “Power On”
Step 1
​
: Ensure that the device is properly installed, and the supply cable is properly
wired, secured and terminated. Turn on all the mcb’s at the front of power-
distribution unit except for the manual maintenance bypass switch. (this should be in
the “OFF” position)
Step 2: ​ Turn on the air conditioning indoor unit switch at air conditioning power box.
Note:
1.
​
These switches are on each device and are not on the power distribution unit.
2.
​
Please make sure the air conditioning pipe connection is correct, the refrigerant
19