ENCON 3661, Инструкция по установке, эксплуатации и обслуживанию, Страница: 2 / 11

Doc. No: 01999901
Revision: A 1 of 10
Issue Date: 08/15/21
INSTALLATION
•
OPERATION
•
MAINTENANCE MANUAL
SAF-T-TUB™ JUMP TANK
MODEL: 01052539
PRODUCT DESCRIPTION
SAF-T-TUB™ Jump Tank system is designed to provide emergency treatment of personnel exposed to pyrophoric oxidizing
agents or in situations when high heat irritants of thick density are involved. The heated re-circulating water bath with its
ergonomic design allows for immediate extinguishing and preliminary decontamination in the 165 gallons of potable water,
which can be treated with Encon Safety Products Hydrosep
Ò
QT water preservative.
SAF-T-TUB™ FEATURES
¨
165 gallon capacity
¨
79” x 30” x 38” full immersion depth
¨
Heated to maintain 85
°
F maximum
¨
Re-circulating to provide even temperature
throughout
¨
Level indication and heater control
¨
Ergonomic design
¨
Double wall insulated annular space
¨
Fire retardant FRP/Gelcoat
Ò
design
¨
Drain valve
¨
Isolated utility tank
¨
1.5 KH immersion heater
¨
Operation indicator lights: Power, Heater, Pump &
Water Level
¨
Two thermostats
Gelcoat
Ò
is a registered trademark of Fibre de Verre Gar
Fiberglass
SPECIFICATIONS
VOLUME 165 Gallon potable water capacity
WATER TEMPERATURE Maintains 70-85
°
F through use of a 1.5 KW two thermostats and level switch
control circuit
ELECTRICAL REQUIREMENT 13.1 amp, 120 volt circuit
GFCI 30mA EPD type circuit protector is required (by others)
ELECTRICAL CLASSIFICATION NEMA 4, and Class 1 Div. 2 Group D models are available
WEIGHT 175 lbs. tare 1545 lbs. full
DIMENSIONS Overall: 78” (L) x 35” (D) x 40” (W)
Inside Tank: 71 1/2” (L) x 28-3/4” (D) x 27” (W)
CONSTRUCTION Double wall insulated fire retardant FRP, R-6 insulation factor
CONTROLS Dual thermostat: Close 70
°
F; Open at 85
°
F
Water level control protection of the immersion heater and recirculating pump
INDICATOR LIGHTS Power On: GREEN ; Heater On: RED ; Pump On: ORANGE
PUMP 100 GPH Submersible
GENERAL INFORMATION
1. SAF-T-TUB™ should be installed in the facility near the point of potential contact, away from the irritant chemical potential
spray area.
2. Placement of SAF-T-TUB™ should be in an area where the path of travel is free of obstructions that may inhibit the
immediate use of the SAF-T-TUB™ and the area should be well lit.
3. SAF-T-TUB™ should be available for immediate use, and should be installed, inspected, and maintained in accordance
with the manufacturer’s instructions.
4. Consideration should be given to the proper disposal of waste flushing fluid.
5. This product should not be used as a substitute for proper emergency decontamination equipment.