16. Use only a UL-approved extension cord of the correct rating to avoid overheating.
17. Do not use attachments that are not provided by the manufacturer because they may cause unsafe
conditions.
18. Do not use the pump for anything other than its intended use.
19. This fountain pump is not intended for commercial use.
ASSEMBLY INSTRUCTIONS
Fig.1
Fig.2
Power cord
A
(Product)
Water
B
(Pump)
PVC plastic tube
LED
4
Reverse the steps in the assembly instructions to replace the pump (B).
Be careful not to spill water onto the plug of the pump.
DO NOT allow the pump to run dry!
Fig.3
3/4 inch (2 cm)
Step 1: Remove the fountain from the box; place the product (A) on a level surface.
S
Step 2: The LED light is pre-installed in fountain. Plug the LED light into the pump (B).
tep 3: Connect the PVC plastic tube to the outlet nozzle of pump (B). place the pump (B) inside water tank
smoothly. Pay attention to have the power cord pass through the back opening.
Step 4: Fill the product (A) with clean water. Make sure the pump (B) is completely submerged in water. The
fountain is completely assembled as shown in Fig.2 In order to have best effect; the water level should
be 3/4 inch (2 cm) below the Basin as shown in Fig.3.
Step 5: Plug the pump power cord to the wall outlet to run the fountain.
