2
Edge Controller Installation Instructions
Edge Controller
INSTALLATION INSTRUCTIONS
EDGE CONTROLLER
Modular Installation
The Edge Controller must be connected to the supplied Encelium Edge Controller Power Supply Unit or an Ethernet PoE network
switch using standard CAT-5 (or greater) Ethernet cabling. If a PoE network switch is not available, a PoE injector (active or passive)
may be used. Ethernet PoE network switch or PoE injector connects to the PoE port pointed by POE-IN arrow.
•
The Edge Controller has been tested in accordance to UL2043 and is suitable to be used in plenum or “plenum rated” areas.
•
The Edge Controller may be installed into a drop-ceiling tile (preferred installation), directly onto a wall junction box, or onto a
wall surface.
AAAAAAAAAAAAAAAA
EDGE CTRL
AAAAAAAAAAAAAAAA
EN-EC-ZB-SW
56330
6NA8
Made in Canada
FCC ID:H79DFZM-E7210
IC ID:4259B-DFZM7210
Max ambient tempe40˚C
For Plenum Use
AAAAAAAAAAAAAAAA
MAC: 00:00:00:00:00:00
yymmdd
POE-I
N
NC
POE-I
N
Upgradable to
Encelium Networked LMS
Encelium Edge
Pay careful attention to the POE-IN and NC labels at the rear of the Edge Controller. The Ethernet cable from the Edge Controller
Power Supply Unit or Ethernet PoE network switch or PoE injector connects to the PoE port pointed by POE-IN arrow.
Ceiling Tile Installation
This is the preferred installation method for maximum antenna performance.
Cut a hole in the ceiling using the supplied template (the cardboard cutout holding the ceiling mount bracket in place in t
he packaging).
Assemble the Edge Controller and the ceiling mount bracket together. Push the ceiling mount bracket until the lock snaps into
the groove.
Push the assembled Edge Controller through the ceiling tile.
Place the upper bracket on to the Edge Controller (above the ceiling tile from the plenum area) until it locks with the lower bracket.
Connect the Ethernet cable to the PoE port using the POE-IN arrow point on the Edge Controller for alignment.
Ceiling Tile
Opening for EEC
installation
PoE Cable from the
SC power supply
GreenBus uses proprietary connectors and jacks for ease of installation only. GreenBus is a proprietary standard. Connect to
Encelium X Lighting Control System only. Do not connect to other circuits.
1
2
3
4