Version
Document Title
Release Date
10
Enapter Water Tank Module 2.0
2021-03-18
Enapter Water Tank Module 2.0
–
Rev.10
–
March 2021
15
electrolyser, make sure to fill the line by turning on the WTM and observing that the water
discharges into an empty container.
When you
’
re using the WTM to feed Enapter
’
s electrolysers, be sure that this port is connected
to the homonym port on the electrolyser’s front side
.
•
OVERFILL port:
Connect the 8mm Ø LLDPE pipe to the OVERFILL port. This is an
outlet port
. From this pipe, the
water stored inside the water tank will flow out only if the high-level sensor
fails
. This is a rare
condition, but please be sure this pipe is connected to the User
’
s drainage system.
Moreover, be sure that at any point, the pipe connected to this port does not overcome the
height of the line that indicates the maximum level (on the level indicator column).
Connections working principle
Bulkhead unions: ports
H2O IN
,
H2O OUT,
and
OVERFILL
of 8 mm Ø.
1.
Cut the tube square and remove sharp edges. Ensure the outside diameter is free of score marks.
2.
Push the tube into the fitting to the tube stop.
3.
Pull-on the tube to check it is secure. Test the system before use.
MAINTENANCE
•
TANK DRAIN port:
This is a
maintenance port
. You will use it in just 2 cases:
1.
Manual refilling of the water tank inside the module:
