I
NSTALLING
T
HE
828W W
EATHERPROOF
P
O
E E
XTENDER
Installation
The Enable-IT 828W – A Dual Output PoE and Gigabit PoE Ethernet Unit has a distance restriction
of 800ft or 240m over 4-pair Category 5e or higher spec rated wiring. Multiple 828W units can be
daisy chained to reach up to 2,000ft or 1,828m. For the 828W daisy chain use additional 828W
units.
•
Total distance limitation of 800ft or 240m from end to end per 828W unit.
•
4-pair CAT 5e .24 AWG or better cabling is required for Gigabit throughput.
•
Wire pairs used must be straight through, no taps/connection points.
Perform an Out Of The Box Test (OOTBT)
We highly recommend that you perform a quick test to ensure the working order of
your Enable-IT 828W Weatherproof PoE Extender Unit units prior to installing.
This will also serve to familiarize you with how easy the process should be. Using a
Ethernet patch cord attach any PoE Injector Output to the 828W left side (single port)
sealed jack as shown below in the diagram.
Next use another Ethernet patch cord to connect one of the 828W right side (dual
ports) jack to your PoE device. Power up your PoE Injector. The left side Green Power
LEDs will turn on and all Yellow Link LEDs will flicker for LAN traffic activity. This
confirms basic proper operation of the units.
For a more detailed test and to confirm your LAN Equipment works with the 828W
units, connect your Ethernet LAN to the PoE injector LAN in port and then test LAN
port and test connectivity all the way end to end.
You will need a long flathead screwdriver to carefully remove the Ethernet patch cables
from the deeply recessed ports prior to installing.
All Rights Reserved © 1997 - 2017 Enable-IT
™
, Inc. Page
!
of
!
2
5
