EMX WEL-200R, Руководство по эксплуатации

Страница: 11 / 20

WEL-
200™ Operating Instructions
10
Document no.
10320104 Revision 2.0 3-1-19
2. Connecting
Connecting is a two step process. First, on the receiver, press and hold the channel assignment
switch until the green status LED begins rapidly flashing, then release; this will clear any existing
assignment for that particular channel. Hold down the connection switch on the transmitter. If it
is not currently connected to a receiver, it will begin flashing rapidly until successfully connecting.
Detailed instructions are given below.
2.1. Apply 12-24 VDC/VAC to the WEL-200R (receiver) , wait for initialization to complete
1
2.1.1. If there are no existing connections, the receiver’s status LED will blink rapidly
while it is finding a clean operating frequency (this can last a few seconds)
2.1.2. After initialization, the system status LED will flash on/off once every 2 seconds
2.2. Set channel to the desired OPEN/CLOSE direction function using the MODE dip switch
2.3. Install 2 AA Lithium batteries in the WEL-200T (transmitter)
2.3.1. The green LED on the transmitter will quickly flash 2x every two seconds
2.4. Install a properly terminated edge to the transmitter (8.2k or 10k termination)
2.5. On the receiver , hold down the desired channel assignment switch until all four channel
LED’s activate and the system status LED begins flashing rapidly, then release the
switch.
2
2.6. On the transmitter , hold down the connection switch (next to the terminal block)
3
2.6.1. The LED on the transmitter will begin flashing rapidly after ~4 seconds
2.6.2. Upon successful connection, the LED will flash once every two seconds
2.6.3. If the transmitter fails to connect, it will return to its initial state, with the LED
flashing twice every two seconds. If this occurs, repeat step 2.6. If the
transmitter will not connect, proceed to the troubleshooting section.