LPe1250 Hardware Installation Manual
Page 3
Figure 2 shows the transceiver partly extracted.
Figure 2: Removing a transceiver
7. Observing electrostatic discharge (ESD) precautions, store the transceiver in an ESD-safe place.
8. Remove the mounting bracket screws from the top of the HBA.
Figure 3: Removing the Bracket
9. Remove the bracket and store it for future use.
10. Align the new mounting bracket tabs with the holes in the HBA.
11. Re-install the screws that attach the HBA to the bracket.
12. Re-install the transceiver by sliding it into the housing. When the latch engages, it clicks.
13. Push the bail back into place.
14. Remove the blank panel from an empty x8 or higher PCIe bus slot.
15. Insert the HBA into the empty slot. Press firmly until the adapter is seated.
16. Secure the HBA's mounting bracket to the case with the panel screw or clip.
17. Replace the computer case and tighten case screws.
The HBA is now installed in the computer and is ready for media attachment.
Note:
Be careful not to push the bracket past the transceiver housing's grounding tabs.
Make sure the light emitting diodes (LEDs) are properly aligned with the holes in the
bracket.
