Install the Host Bus Adapter Board
Record IEEE and serial numbers.
Each host bus adapter port is shipped with a unique address identifier
called the IEEE address. Since this adapter has two ports, there are two
IEEE addresses. The IEEE address is used when configuring your
system. The serial number is used when communicating with Emulex.
All numbers are clearly marked on the board. We recommend that you
record these numbers before installing the adapter.
1.
Turn off and unplug the computer.
2.
Remove the computer case.
3.
Remove the blank panel from an empty PCI/PCI−X bus slot.
4.
Note
The LP9402DC can only be used in a 3.3V signaling
slot. 66 MHz, 64−bit PCI slots and 66/100/133,
64−bit PCI−X slots are 3.3V signaling slots. The
LP9402DC is keyed so it cannot be installed in an
incorrect slot.
This product supports 64−bit PCI operations only.
Insert host bus adapter board into the empty PCI/PCI−X bus slot. Press
firmly until seated.
5.
Secure the host bus adapter's mounting bracket to the case with the panel
screw or clip.
6.
Replace the computer case and tighten case screws.
7.
The host bus adapter is now installed in the PC and is ready for media
attachment.
Emulex Drivers, Software and Manuals
4
