Emulex LP1050, Инструкция по установке и справочник

Страница: 5 / 20

Note
The host bus adapter comes with a standard PCI
bracket installed. The low-profile mounting bracket
is shorter than the standard bracket;
approximately 3.11 in. (7.9 cm) compared to 4.75
in. (12.06 cm) long.
If you need a low-profile bracket, contact Emulex
Product Information by phone at 800-EMULEX-3
(800-368-5393) or 714-885-3450, or by e-mail at
info@emulex.com. A low-profile bracket will be
shipped within one business day
.
5. Remove the mounting bracket screws from the top of the
host bus adapter.
6. Remove the bracket and store it for future use.
7. Align the new mounting bracket tabs with the holes in the
HBA.
Note
Be careful not to push the bracket past
the transceiver housing's grounding tabs.
Make sure the LEDs are properly aligned
with the holes in the bracket.
8. Replace the screws that attach the HBA to the bracket.
9. Insert the host bus adapter into the empty 32- or 64-bit PCI
or PCI-X bus slot. Press firmly until it is seated.
10. Secure the host bus adapter's mounting bracket to the case with the panel
screw or clip.
11. Replace the computer case and tighten case screws.
The host bus adapter is now installed in the PC and is ready for media attachment.
Emulex Documentation, Drivers and Software
5