3.Mount the LED stands
3.1 Mount the two LED stand hooks onto the LED stand A and B. Please refer to the guide below for details:
3.1.1 Mount the hooks on top of the LED stands 3.1.2 Finished diagram
3.2 Either mount the LED stands beside the screen as shown in figure 1, refer to 3.2.1,
or mount the LED stands above and below the screen as shown in figure 2, refer to 3.2.2.
For huge projectors, mount the LED stands inside the screen as shown in figure 3, refer to 3.2.3.
3.2.1 Mount the LED stands A & B beside the screen. The position of the two LED stands could be swapped. See figure 1.
3.2.2 Mount the LED stands A & B above and below the screen. The position of the two LED stands could be swapped.
See figure 2.
3.2.3 Mount the LED stands A & B inside the screen. The position of the two LED stands could be swapped. See figure 3.
figure 1
figure 2
figure 3
3.3 To provide power for the LED stands, please connect the cable of the LED stands to any USB port, via the
"USB power cable". If the console is too far away from the screen, user may consider to provide power with
an "AC – DC power transformer" instead. (it is not included in the package)
AC – DC power transformer requirements : 600mA or above, 5V
Note : 1. The distance between the TopGun and the screen should be 2-3 times of the distance between the two LED
stands. (for LED stands mounted beside the screen)
2. For 16:9 or 16:10 screens, or screen of size 42 inches or above, it is recommended to mount the LED stands
above and below the screen. This enables TopGun to work nearer to the screen. (e.g. For 42 inches 16:9 screen,
if the LED stands is mounted above and below the screen, the minimum workable distance between TopGun and
the screen is 180cm. If the LED stands is mounted beside the screen, the minimum distance becomes 220cm.)
3. For huge projectors, or for screens of 52 inches or above and the provided LED stands does not function well,
user may consider to buy our TopGun Blaze stand
II
(#0802) to replace the provided LED stands.
TopGun Blaze Stand
II
official site:
http://www.hkems.com/product/xbox/TopGunBlazeStand2.htm
4. User could use the double sided tape provided to mount the LED stands. See
(1.6)TopGun packaging list
.
5. No matter single TopGun or multiple TopGun installation, only one pair of LED stands is needed for a screen.
6. All 4 sets of infrared LED on the LED stands are not visible, while the red LED will indicate if power is ON.