3.3 Switch 5: CDMA Modulation
A different calibration table is needed for CDMA operation. Turn on switch 5 for
CDMA use.
Modulation
Switch 5 Position
CDMA
On
All other
Off
3.4 Switch 6, 7, and 8: Downlink Peak Power Limit
For initial power-up, turn all these switches “off”. See Appendix B for full details.
This completes the configuration switch settings. Leave the cover off so adjustments
can be made later if needed.
4.0 Installing the EkoMini
TM
:
Only qualified technicians should perform the installation. The user is cautioned that
modification or changes to this device not expressly approved by
EMS Wireless
could void the user’s authority to operate this equipment.
The EkoMini
TM
is designed for indoor use only. It should not be mounted outside.
•
Determine the donor and server antenna(s) locations. Choose a
location for the EkoMini
TM
that will minimize coaxial cable lengths to
these antennas, while maintaining adequate isolation. Also choose
a protected area such as an electrical or telephone room so the
EkoMini
TM
will not be physically damaged. The location must also
be near a 100 - 240 VAC, 47 – 63 Hz outlet.
See Figures 3 and 4
below – do not apply AC power without the coaxial cables and
antennas installed! If this is done, disconnect and then
reconnect the DC power cable after the antennas are
connected. This will initiate a software reset.
