EMQ e-bike V 3.0 2022, Руководство пользователя

Страница: 7 / 20

NOTE! Do not extend the seat post beyond the maximum height
Indicated on the seat post itself.
This marking is on the front of the pen, facing the handlebars.
Push the rear wheel from under the bicycle backwards with your foot:
✓ Put your right foot on the rear wheel axle
✓
With your left hand you hold your handlebars, with your right the saddle
✓ You leave your front wheel on the ground, while simultaneously pushing the rear wheel
under the bicycle with your foot
Below you can see the movement that the rear wheel makes. You keep your right foot on the rear
wheel axle throughout the movement.
3.3 Rear wheel
N
OTE
:
WHEN UNFOLDING
,
THE CHAIN GOES FROM A RELAXED TO A TENSIONED STATE
. A
LWAYS DO THIS WITH CARE
AND ATTENTION
:
THE CHAIN MUST BE GIVEN TIME AND SPACE TO FIND THE TEETH OF THE SPROCKET AGAIN
.
Make a rolling movement with the e-bike, during the last part of the rear wheel unfolding where the chain
becomes tense.
Do you notice that the chain is already fully tensioned, while the e-bike is not yet fully unfolded? And does
the chain not move when you let the wheels roll? Then the chain is not seated properly on the rear
sprocket. This can be remedied in almost all cases by folding the rear wheel back for a while, and then
letting it unfold slowly while rolling the e-bike back and forth. You will then hear a few clicks, and notice that
the chain is in the correct position again.
The chain is good if the chain moves with you when you move the wheels (and therefore the sprockets).
Only when the chain is in place do you push on and the e-bike is completely unfolded.
Do you keep pushing even though the chain is not in the right place? Then the rear sprocket cover breaks.
This is not covered by the warranty and can be easily avoided by following the above instructions.