Version 1.0 Sep. 2007
1 GENERAL
INFORMATION
This Secure Drive Enclosure kit
package contains:
•
HDD Enclosure
•
USB-Y cable
•
Software, Driver and Manual CD
•
Quick Start Guide
•
Pouch
•
Screws / Screwdriver (for applicable models only)
2 GETTING STARTED
Hardware
Installation
Assembling your hard drive to the Enclosure kit
Note:
The pictures are only for illustration and actual accessories may
differ from picture
.
3 SETTING
UP
Security Software Setup
1. Insert the Installation CD into your CD-ROM drive.
Select “
Software & Win98 driver
”.
2. When this screen appears,
For Windows 98/SE:
Select “
Install Win98 Driver
” before proceeding to next
step.
For Windows XP/Me/2000/Vista
Select “
Configure to Secure Drive
”.
Caution:
Configuring to
Secure Drive
destroys any existing data. Be sure to
back up the disk contents first.
3. When this screen appears, follow the on-screen instructions.
1) Enter
【
New Password
】
2) Re-enter
【
Confirm New Password
】
3) At
【
Hint
】
prompt, enter a suitable phrase to help you recall
your password later on.
4) Click
【
Prepare Secure Drive
】
4.
When the installation is complete, please re-connect the USB
drive into the computer’s USB port for the new configuration to
take effect.
Note
: In order to remove the device to take effect, you could choose either
device’ end or computer’s end (USB Y cable) to unplug and re-plug
the USB cable. Otherwise, system will still show the old data in the
drive.
1. Turn to the rear side and remove
the rear case. Align the hard
drive’s interface connector to the
on-board connector.
2. Gently lower the hard
drive till it rests flat
against the board.
3. Fasten the hard drive’s mounting
holes to the Case Frame with 2
bigger screws.
4. Finally, fasten all the four
smaller screws at both sides of
the Case
Quick Start Guide
•
Mac users please refer to Mac user guide in utility CD.
