Empress Effects Superdelay, Руководство пользователя

Страница: 17 / 20

16
Using Presets
The Empress Effects Superdelay has 8 preset locations where users can
store and recall their favourite settings. All the settings of each mode can be
stored except for the audio loop in Looper Mode. When first powered up,
the unit operates with the settings that are on the knobs, as opposed to a
preset being automatically loaded.
Preset Organization
The 8 presets are represented by a series of LEDs located just below the
knobs. Press the
presets switch to scroll through the presets. When cycling
through the presets, the small yellow LEDs below the knobs will turn on,
from left to right, representing preset locations 1 through 4. Then, the small
red LED below the mix knob will light and the small yellow LEDs will again
turn on, from left to right, representing preset locations 5 through 8.
When cycling through the presets you will notice that after preset 8, all the
small LEDs will flash very quickly. This represents the ‘knob preset’ location.
If you recall this preset the Superdelay will get its settings from the current
knob and switch positions on the unit. In ‘knob preset’ no small LEDs will be
lit. This is essentially going back to manual mode.
Saving a Preset
To save a preset, set the controls to the sound you would like to save. Then
press the preset switch until you reach the preset location in which you
would like to save. While the lights are flashing, press and hold the save
button and then press the preset button. Your preset is now saved.