Empower CD334, Инструкция по эксплуатации, Страница: 6 / 13

SAFETY INSTRUCTIONS FOR BATTERIES AND CHARGER
5
BATTERY
▪
Never attempt to open or modify battery for any reason. Released electrolyte is
corrosive and may cause damage to eyes and skin. It may be toxic if swallowed.
▪
Under extreme conditions, battery leakage may occur. When you notice liquid on
the battery, proceed as follows:
•
Carefully wipe the liquid off using a cloth. Avoid skin contact.
•
In case of skin or eye contact, follow the instructions below.
•
The battery fluid, a 25-30% solution of potassium hydroxide, can be harmful.
In case of skin contact, immediately rinse with water. Neutralize with a mild
acid such as lemon juice or vinegar. In case of eye contact, rinse abundantly
with clean water for at least 10 minutes.
▪
Do not expose to water.
▪
Do not store in locations where the temperature may exceed 104°F.
▪
Charge at room temperature:
32
°F-1
13
°F. It is normal for the battery charger to
hum and be warm but not hot during operation.
▪
Charge only using the charger provided with the tool.
▪
Before charging, make sure that the battery is dry and clean.
▪
Use only the battery supplied with your tool.
▪
Exercise care in handling and storing batteries in order not to short them with
conductive materials such as rings, keys, coins. There is a real risk of the battery
or the conductor overheating
which can
caus
e
fire or burns.
▪
Do not dispose of battery in fire. It may explode. Follow instructions and
regulations given by local authorities concerning environmental protection.
Dispose of old batteries at an appropriate waste disposal facility.
CHARGER
▪
Use your charger only to charge batteries supplied with your tool. Other batteries
could burst, causing personal injury and damage.
▪
Never attempt to charge a non-rechargeable battery.
▪
Have defective cords replaced immediately.
▪
Do not expose to water.
▪
Do not open the charger.
▪
Indoor use only. Do not recharge the battery in rain or in wet conditions.
SPECIFICATIONS
Voltage: 24V Max
NO Load Speed: 0-350/0-1350RPM
Chuck Size: 1/2"
Chuck Type: Single Sleeve
Max Torque: 350in-lbs (40N.m)
Torque Setting: 23+1
Battery Type: Li-ion
Charging Time: 1-2Hours
Mode Select: Drilling
Driving
Built-in LED Work Light
Includes:
1 pc 24V Cordless Drill
1 pc 24V Lithium-ion battery(2000mAh)
1 pc Charger
1 pc Double-end driver bit
1 pc Metal Belt Hook
1 pc Instruction manual