INSTALLATION TIPS
This appliance should be mounted to the bottom of a standard wall cabinet. If the
hood must be mounted directly to the wall, secure the hood to wall studs.
Ductwork can be installed vertically or horizontally.
Duct runs should be as short as possible.
Avoid the use of 90 degree elbows or use 2 x 45 degree.
Use aluminum tape at all joints.
Do not use duct smaller than the discharge on the hood ( 6” round duct).
LOCATION PREPARATION
Under Cabinet mounting:
1. Use the dimensional drawings below to lay out the range hood’s mounting holes,
wiring access and ductwork by marking the cabinet bottom and drywall where
applicable.
2. Make cutouts for wiring and ductwork.
3. Install the ductwork so that it is flush to the range hood’s mounting surface.
4. Run two-con ground wire from a power source to the hood location. Bring