39010-0-1018
Page 14
OPTIONAL FBB5 SINGLE SPEED BLOWER INSTALLATION INSTRUCTIONS
5. Next, find the fan control switch and wire assembly. Feed the
wires through the hole at the top of the firebox, and secure the
fan control switch with the two screws provided.
See Figure 23.
FAN CONTROL
WIRE ASSEMBLY
Figure 23
6. The fan control wires will slide down between the firebox and
outer wrap near the blower assembly.
See Figure 23.
7. One fan control wire will have a 1/4” female terminal that must
be attached to the open terminal on the blower motor.
See
Figure 26, Connection A.
8. The other fan control wire has a 1/4” male terminal. Attach this
terminal to the open terminal on the blower power cord.
See
Figure 26, Connection B.
9. Route the wires away from moving parts of the blower assem-
bly and retain wires together near the blower motor using the
plastic purse clip provided.
10. To complete the installation, plug the power cord into the junc-
tion box receptacle at the right rear corner of the firebox outer
wrap.
See Figure 24.
Figure 24
11. If room permits, the power cord can be located from the out-
side of the unit looking through the junction box access hole
(with the junction box removed), then plug up the power cord
before reinstalling the pre-wired junction box.
12. Once all connections are made electrically, it is recommended
that you test the blower fan control operation by turning on
power to the blower
(
CAUTION:
110 Volt).
Then apply heat to
the fan control switch inside the firebox with a lighter or match
until blower is activated. Once blower is activated, check for
proper operation. Do not place hands near blower assembly
or other wiring while power is on.
13. Replace blower access plate.
14. This completes the installation of the optional FBB5 Blower kit
accessory.
NOTICE:
This blower is equipped with a heat activated fan control
switch. Blower will operate when the fireplace warms up, and will
turn off automatically when the firebox cools down.