19481-2-0115
Page 2
INSTALLATION
1. Pre-install the two glass door spring clips at each end
of the top door track as shown in Figure 1. Use four
#8 x ½” Ph Hd screws to attach the clips, but do not
fully tighten.
SPRING CLIP
#8 x ½” PH. TRUSS HD.
Note: Door track illustrated upside down for clarity.
Figure 1
2. Install the Upper Door Track to the fireplace as shown
in Figure 2 using two #8 x ½” Ph Truss Hd screws at
each end. Match up the holes in the track end tabs with
the pilot holes in the sides of the fireplace. See Figure
2.
UPPER DOOR TRACK
Figure 2
3. Install the Canopy by first removing the upper louver
assembly (if applicable). Flush face fireplace models
will have a 3/8” high opening just above the firebox that
will accept the canopy’s rear tabbed flange. With the
canopy tilted slightly upward, insert the canopy so that
the rear locator tabs lock into the slots located in the
firebox top. Rotate the canopy downward and install
one #10 x ½” Hex Hd screw at the center of the canopy.
This screw will be installed from inside the firebox. The
location is midway between the two firescreen rods at
the center of the fireplace. Secure the canopy with this
screw, but do not overtighten. See figure 3.
PLACE REAR TABS ON
CANOPY INTO SLOTS
IN FIREBOX TOP
CANOPY
#10 x ½” HEX HD. SCREW
TOP DOOR TRACK
Figure 3
4. Install the decorative handles to the Right and Left
Bifold Glass door assemblies as shown by the exploded
parts view, Figure 8. To install the door handles, insert
four #8 x 7/8” screws from the rear of the door trim and
secure into the handles. Do not overtighten.
f i r e - p a r t s . c o m
