5.0 Inspection and Installation
5.1 The 16, 25, & 57 Watt Retro-Fit UV Sterilizer is shipped
from our factory as shown here:
- Power Supply mounted on the Cord (Power Assembly)
- Quartz Sleeve Assembly & UV Lamp
-
Jamb Plate and Instructions
Please inspect these items for possible shipping
damage before use. Thoroughly inspect the quartz
sleeve and uv lamp for damage of any kind as they
are made of glass and are easily breakable.
5.2 Remove the bubble wrapped lamp & quartz sleeve from
the triangle box. Also remove the grey jamb plate from the
envelope on the outside of the same box.
5.3 With the quartz sleeve assembly, UV lamp, and Power
Assembly lying flat, unthread/remove the plastic threaded
cap (may be blue or red) on the clear power assembly.
Then remove the foam packing insulation (these items are
for shipping purposes only, please discard). Next pull the
lamp out of the quartz sleeve and set it aside.
5.5 Gently slide the lamp now connected to the power cord
back into the quartz sleeve assembly, screwing down the
gray adapter into the clear quartz sleeve module until snug.
Next, screw down the black jamb nut till it is snug.
5.6 Your Retro-Fit UV Sterilizer is now ready to be installed
inside the filter.
5.7 Slide the quartz sleeve end of the unit gently into the UV
chamber of the filter, locking the jamb plate pins in place
using a quarter-turn.
5.4 Place the gray jamb plate onto the clear quartz sleeve
module with the pins facing towards the quartz sleeve. Next
Connect the lamp’s 4 pins to the 4-pin lamp connector.
