Specifications
T5/10PNP-3
T5/10PCA-3
T4/8PNN-3
T4/8PCN-3
Dimensions (w,d,h)
12.7 x 10.4 x 4.1 cm
Temperature Range
−30 – +70 °C
* TERR: EN 50083-3/60dB IMA3 [dBuV]; SAT: EN 50083-3/35dB IMA3 [dBuV]
3) Product Takeover
Make sure that the product is not damaged. Please contact your dealer in the case of damage.
4) Product Storing and Installation
We recommend the device to be installed and serviced by the qualified technician.
The product must not be stored and installed
•
in the place with excessive humidity
•
in the place with excessive dust pollution, mechanical vibrations or impacts
•
in the place out of temperature limits specified in the section 2) Technical Specifications
•
close to heat sources (radiators or air ventilators, direct sunshine etc.)
•
in the reach of children.
Do not expose the apparatus to dripping or splashing. Use the apparatus only in moderate climates (not in
tropical climate).
Fix the product firmly on a wall or another hard and inflammable surface with screws and dowels.
•
The product shall be in no case held only by the connected cables.
•
Do not cover the product (with curtains etc.).
•
Do not place any containers with liquids (vases, glasses etc.) or naked flame sources (lighted
candle etc.) on the product or near the product.
5) Product connection
Connect the product in accordance with this manual and valid regulation in your country. Use high quality
75 Ω coaxial cable designed for satellite reception. Mount the F connectors (screw, crimp or compress type)
on the ends of coaxial cables. Connect the F connectors into the F sockets of product and fasten them with
an appropriate force. The coaxial cables shall not be broken, the minimum bending radius should be 5 cm.
Where appropriate it is possible to use quick Fm–Fm adaptors instead of cables.
•
Connect F sockets marked SAT IN (possibly TERR IN) to Quattro / Quad LNB (terrestrial
antenna) or to F sockets marked SAT OUT (TERR OUT) of preceeding distribution unit.
•
Connect F sockets marked SAT OUT (possibly TERR OUT) to input F sockets of multiswitch or
other distribution unit.
Note: If needed, DC supply for LNB must be provided at straight outputs.
The wiring examples are shown in the section 9) Wiring Diagrams or at www.emp-centauri.eu.
2 of 4
