Emotron EMX-B, Инструкция по эксплуатации

Страница: 34 / 60

30 Built-in functions
CG Drives & Automation 01-6048-01r3
3.9.2 Setting DIP switches
WARNING!
Disconnect the voltage supply before changing the DIP switch setting.
NOTE: After changing DIP settings the control unit must be power
cycled before the new settings become active.
Table 7 DIP switch setting
Speed
Please refer to section chapter 3.9.1 page 28
for different speed presetting
Direction of rotation, DIP 5
Clockwise from shaft end (Default setting).
DIP 5=Off
Counter clockwise from shaft end.
DIP 5=On
Rotation monitor, DIP 6
Internal rotation monitor (Default setting)
DIP 6=Off
External rotation monitor (External sensor required)
DIP 6=On
Control signal, DIP 7
0-10 V / 0-20 mA (Default setting)
DIP 7=Off
2-10 V / 4-20 mA
DIP 7=On