Emotiva XPA-1, Руководство пользователя

Страница: 16 / 37

10. Left Channel XLR/Balanced Input ‐ Connects with an XLR/Balanced cable to the left channel output of a preamplifier or
processor.
11. Left Channel Speaker Terminals ‐ Connects to the left side speaker inputs. These 5 way binding posts accept stripped
speaker wire, banana plugs (single or dual), or spade connectors. Be sure to observe correct polarity when connecting
speakers and be sure that the wires do not touch between positive and negative terminals.
12. Right Channel Speaker Terminals ‐ Connects to the right side speaker inputs. These 5 way binding posts accept stripped
speaker wire, banana plugs (single or dual), or spade connectors. Be sure to observe correct polarity when connecting
speakers and be sure that the wires do not touch between positive and negative terminals.
Note: Potentially lethal voltages present! Never connect, disconnect or modify speaker wiring with the amplifier turned
on.
Note:
In BALANCED mode, connect the single speaker to the Left C and Right C speaker
terminals.
13. IEC Power Cable Connection
14. Master Power Switch ‐ This rocker switch provides the master power for the amplifier. After it is in the ON position, the
amplifier can be turned on manually from the front panel switch or automatically with the trigger input via 3.5mm input jack.
Under normal use, this switch should remain on, leaving the amplifier in standby position, and coming to full power with
either the front panel ‘STANDBY’ button, or activation through the remote trigger. In ‘STANDBY’ mode the power button will
emit an amber glow, but the unit is not fully powered. A small amount of amps are used in this mode, less than an average
night light would use. If you are away for an extended period of time (more than a few days), shut off all power to the
amplifier with the main power switch on the back of the amplifier.
1
5. Voltage Indicator ‐ All Emoitva amplifiers operate on either 115V or 230V. The voltage is detected when the amplifier is
turned on, and is identified by the indicator lights. There are no user adjustments, the amplifier automatically adjusts to the
16