Setting Up The VSUB-1
Connections -
Connect the Line Input on the VSUB-1T
to the unbalanced subwoofer output on your processor
or AVR. Connect the Line Output on the VSUB-1R to the
unbalanced input on your subwoofer. (If your processor
or subwoofer doesn’t have an unbalanced connection,
you may use a passive balanced-to-unbalanced adapter
with either.)
Pairing -
Before using the VSUB-1 system, you must
pair your receiver with your transmitter. With both units
powered on, press and hold the Pairing button on the
VSUB-1T transmitter for several seconds until the Power
LED starts blinking. Now press and hold the Pairing
button on the VSUB-1R receiver, until the Power LED
blinks off and then on again, and you hear a loud beep
tone from the sub.
If you have other VSUB-1R receivers you wish to pair
with the same VSUB-1T transmitter, simply repeat the
pairing process with each. Units remain paired when
powered off.
Configuration -
There is no configuration required for
either the VSUB-1T or VSUB-1R.
- If your processor or AVR has room correction or
calibration software, it should be run or adjusted after
setting up and connecting the VSUB-1.
- If your subwoofer has a Volume or Gain control, it
should be set so that your subwoofer reaches full output
with an input level of between 1V and 2 V RMS.
- If you notice your subwoofer clipping on passages with
very loud bass, turn the Volume or Gain control on your
subwoofer up, and lower the subwoofer output level on
your processor or AVR.
