Emotiva airmotiv vaulta AVL-6.5, Руководство пользователя

Страница: 12 / 20

Page 10
AIRMOTIV VAULTA AVL- 6.5
1) Before installing your Airmotiv Vaulta AVL - 6.5 loudspeakers you should first run appropriate
speaker cable to the location where they are to be installed. We suggest using high quality
moderately heavy gauge speaker cable rated for in-wall or in-ceiling use (14 gauge or thinner
is usually most appropriate for ceiling speakers).
2) Choose the location for each of your Vaulta loudspeakers.
3) Double check to confirm that you have adequate clearance behind and to the sides of your
chosen location.
4) Mark an 8” circle at the location where each speaker is to be installed using the provided
template.
5) Carefully cut out the 8” round mounting hole for each speaker using a drywall saw or utility
knife - whichever is appropriate for your ceiling material.
6) Pull your pre-installed speaker cables out through the hole and trim them to the proper length.
Allow some slack so you have room to work with the wires.
7) For optimum sound quality, we suggest placing a block of full-thickness fiberglass insulation
above each speaker, extending at least 18” in each direction, if space permits you to do so.
8) Strip the ends of each wire in your speaker cable to prepare for connecting them to your Vaulta
speakers.
9) At this point look closely at your Vaulta loudspeakers and note the direction in which the
tweeter tilts. Plan to orient each Vaulta speaker so that you can adjust the tilt of the tweeter
towards your your prime listening position.
10) Connect the speaker wires to the terminals on each Vaulta speaker, lift the speaker into
position, and tighten the locking screws to engage the locking arms and lock each speaker
into position.
11) Adjust the angle of each tweeter and attach the grill to the speaker.
(Refer to the illustrations on the next page for details.)
NOTE:
BE CAREFUL HOW YOU SUPPORT THE SPEAKER DURING INSTALLATION.
You may support the weight of the speaker by placing your hand or hands against the front of
the mounting frame.
DO NOT attampt to support the speaker by placing your hand or fingers directly on the cone or
suspension of the mid/woofer. Doing so will result in damage to your speaker.
NOTE:
WE STRONGLY RECOMMEND USING A MANUAL SCREWDRIVER FOR THIS OPERATION.
DO NOT overtighten the mounting screws. Screws must be tight enough to pull the locking
arms against the top of the ceiling and hold the speaker firmly in place. If the screws are
overtightened the locking arms may cause the surface of the ceiling to buckle, resulting in a
less secure installation, and a speaker that fails to sit flush against the ceiling.